LOAD (LOA)

Qualifiers:

IPDevice <1>, <2>, ... <1400>

IPDevice <1> TO <300>

Controller

Notes:
The Load command uses TFTP connections to transfer software to IP devices. Because the 3300 ICP supports a maximum of 300 TFTP connections at any one time, you must issue the command multiple times to load software to a large number of IP devices. For example to load software to 500 IP devices, you must issue the command twice:

LOAD IPDEVICE 1 TO 300
LOAD IPDEVICE 301 TO 500

If you enter the "Load" or "Load 1" command, the system reboots.
After you issue either of the following Load commands, it is recommended that you reset the system:

LOAD CONTROLLER or
LOAD 1 3 32

The AX controller only supports the "Load" command, without any qualifiers. You cannot use the Load command for the line cards in an AX controller.

Loads software into device/unit processors.

The <unit/module> qualifier loads software into the unit number selected (ASU, NSU, or controller).

The IPDevice <1>, <2>...<1400> qualifier loads software into an individual IP device.

The IPDevice <1 TO 300> qualifier loads software into all IP devices (up to 300 devices at a time)

The Controller qualifier loads software into the DSU, Peripheral Unit, DNIC and Digital Line Cards.

Note: Does not affect the DS1 Formatter, CEPT Formatter, Universal T1/E1, PRI T1/E1 and R2 cards.

On the SUPERCONSOLE 1000, this command is found under the SYSTEM group of commands.