You can set the date and time
from any attendant console, or
from the System Administration tool by using the Date and Time form.
from the System Administration tool by using the WriteDateTime maintenance command.
This date and time appears on all SMDR, traffic measurements, data dumps, display telephones, and attendant consoles.
Notes:
System Date and Time uses a Network Time Protocol (NTP) server and settings, which are based on Coordinated Universal Time (UTC), and should be accurate to within one second. If system Date and Time is enabled, you cannot use an attendant console or the WriteDateTime command to set the date and time manually.
When the time or date of the switch has been changed, you must reset Bandwidth Management Statistics, using the BWM Statistics Reset command.
The time format (12 or 24 hour) is controlled by the attendant.
Setting date and time from an attendant console is not allowed when NTP is enabled in the Date and Time form.
None.
SUPERCONSOLE 1000 and 5540 IP Console
To set the date and/or time:
Press Function.
Press Att Function.
Press Date Time.
Press Set Date.
Do one of the following:
To set a date, press set date and enter the date (YY MM DD).
To set a time, press Set Time and enter the time in 12 or 24 hour format (press PM if required for 12 hour format).
Press Set.
Press Exit.
To choose 12 or 24 hour format:
Press Function.
Press Att Function.
Press Date Time.
Press 12/24
Hr.CLK
when AM or PM appears in the display, the system is in 12 hour format.
Press Exit.
To view the date:
Press Function.
Press Att Function.
Press Date Time.
5550 IP Consoles
To set the console time:
Choose Options on the Tools menu.
Select Time.
Select the option you want.
Click Apply or OK.
To set the system date and/or time:
Choose Connect to ESM in the File menu.
Follow the instructions to change the date and time.
