The Single Line DNI Sets form is used to program Single Line DNI telephones. Use this form when performing the following tasks:
This form does not apply to the CX, CXi, CX II, or CXi II controller.
When deleting DNI sets, you must also delete the corresponding directory entries and voice mailboxes.
|
Parameter |
Description |
Default Value |
|
Cabinet, Shelf, Slot |
System-generated, protected field. Identifies the card position. |
|
|
Circuit |
System-generated, protected field. Identifies the hybrid circuit used for the associated device. |
|
|
Device Type |
Select the attached device type. |
|
|
Number |
Enter a unique number up to seven digits in length to be assigned to the line circuit. This is the number dialed to ring the telephone. |
Blank |
|
Local-only DN |
Allows you to specify the directory number as a local-only directory number in a cluster. This field only appears in the form if your system has been migrated to support Remote Directory Number Synchronization. |
Not Selected |
|
Interconnect Number |
Enter a number, between 1 and 64, that references an entry in Interconnect Restriction. |
Blank |
|
Non-Busy Extension |
Select "Yes" to indicate that the associated extension is a non-busy extension; leave the entry blank, to indicate that the set is a regular extension. A non-busy extension requires a COS that has the conference option enabled. |
Blank |
|
Tenant Number |
Enter the number of the set's tenant. |
1 (landlord) |
|
User PIN |
Enter a password for the user PIN. The PIN can only include digits from 0 to 9 and can be from 0 to 8 digits in length. |
Blank |
|
Confirm User PIN |
Re-enter the password to confirm. |
Blank |