This test takes approximately 15 minutes to complete on each trunk. While the test is running on a trunk, the system takes the trunk out of service.
CAUTION: Only run this test at the request of Mitel Technical Support. System performance could be degraded while the test is running.
Note: Only run these tests after business hours during periods of low call traffic.
To run the tests
Ensure that you have configured the system to support testing. See
Access the Line Quality Measurement form.
Click Run Test.
Select the Test Type. To test a single trunk select Individual Distortion/Echo then select the PLID of the trunk. To run the test on all the eligible LS trunks in the system, select Batch Distortion/Echo. The PLID field is disabled.
Click Run.
If the test is successful, the test results are saved in the "/db/database/LSMeasure" directory. If the test fails, an error message is displayed. See Error Messages.
Run a System Diagnostic Report to automatically collect all the echo/distortion files. Then, send the System Diagnostic Report files to Mitel Technical Support for analysis. See System Diagnostic Reporting for instructions.
