The Single Line IP Sets form is used to program the 5001 IP single line telephone. This form uses Range programming. Use this form when performing the following tasks:
When deleting IP sets, you must also delete the corresponding directory entries and voice mailboxes.
|
Parameter |
Description |
Default Value |
|
Device ID |
System-generated, protected field. Lists the programmed Device ID. |
|
|
Device Type |
Select the attached device type. |
5001 IP |
|
Number |
Enter a unique number up to seven digits in length to be assigned to the line circuit. This is the number dialed to ring the telephone. |
Blank |
|
Local-only DN |
Allows you to specify the directory number as a local-only directory number in a cluster. This field only appears in the form if your system has been migrated to support Remote Directory Number Synchronization. |
Not Selected |
|
Interconnect number |
Enter a number, between 1 and 64, that references an entry in Interconnect Restriction. |
Blank |
|
Non-busy Extension |
Select "Yes" to indicate that the associated extension is a non-busy extension; leave the entry at No to indicate that the set is a regular extension. A non-busy extension requires a COS that has the conference option enabled. |
No |
|
MAC Address |
Enter the Media Access Control identifier for the IP telephone. |
Blank |
|
Tenant Number |
Enter the number of the set's tenant. |
1 (landlord) |
|
User PIN |
Enter a password for the hot desk user, SIP Phone user, or the Phone Lock feature. This field is available if the Hot Desk User or Generic SIP User field is set to "Yes". The PIN can only include digits from 0 to 9 and can be from 0 to 8 digits in length. |
Blank |
|
Confirm User PIN |
Re-enter the password to confirm. |
Blank |