This procedure registers the IP devices with the 3300 ICP database, and records the MAC address of the IP device in the database.
Ensure a Set Registration Access Code is assigned in the System Options form.
Ensure the directory number and device type is programmed in the Single Line IP Sets form or Multiline IP Sets form.
For the 5560 IPT , ensure that the master and slave directory numbers are programmed in the 5560 IPT Master/Slave Association form.
To register IP telephones (except 5302 IP Phone, see below):
Connect the IP telephone to an RJ-45 Ethernet port on the LAN.
Provide power to the IP device (refer to the Hardware Technical Reference Manual for power option information. See About the 3300 ICP Documentation Set for information on the Hardware Technical Reference Manual.)
Press * during power-up (to clear any PIN number in memory).
Type the PIN number at the prompt on the IP device.
Prompts
The 5001 IP Phone and 5201 IP Phone display a solid message light.
All other IP Phones and IP Phones show "Enter the PIN number" on the display.
Complete one of the following:
Press Hold for the 5001 IP Phone, 5005 IP Phone, 5201 IP Phone, 5205 IP Phone, 5320 IP Phone, 5330 IP Phone, 5340 IP Phone, 5360 IP Phone, TeleMatrix 3000IP Phone.
Press SuperKey for the 5010 IP Phone, 5207 IP Phone, 5212 IP Phone, 5215 IP Phone, 5215 IP Phone (Dual Mode), 5020 IP Phone, 5220 IP Phone, 5220 IP Phone (Dual Mode), 5224 IP Phone, 5312 IP Phone, 5324 IP Phone, and Navigator.
Press OK for the 5140 IP Phone and 5240 IP Phone.
Press the Send softkey for the 5230 IP Phone.
Press the Hold key for the 5560 IPT.
The set completes initialization.
Note: Use the System Administration Tool to program all other station features (for example, Class of Service, Interconnect Restriction, Set Key Assignments, and Class of Restriction).
To register 5302 IP telephones:
You do not use a PIN number to register an 5302 IP telephone. Instead you use the Login PIN (SIP authentication password) that is assigned in the Multiline IP Sets form.
Connect the IP telephone to an RJ-45 Ethernet port on the LAN.
Press and hold down the * key until all three set indicator lamps are flashing.
When the 5302 IP Phone indicator lamps are flashing,
enter
the directory number, enter
# followed by the Login PIN followed by #
or
if the Login PIN field in the Multiline IP Sets form is blank, enter the directory number followed by ##.
The set completes initialization.
When using the 3300 ICP in a cluster, the actual registering sequence of the IP device is unchanged provided the following guidelines have been observed:
The Cluster Element ID programmed in the Cluster Elements form must match the ICP/PBX Number programmed in the ICP/PBX Networking form.
In a clustered environment, each member of the cluster must be able to see the directory numbers programmed on the other controllers. You maintain the cluster telephone directories either via RDN Synchronization.
The Set Registration Access Codes and Set Replacement Access Codes must be the same for each controller in the cluster.
Each IP Phone must be able to retrieve the IP address of one of the controllers in the cluster (see program DHCP server instructions).