Ensure that the SX-200 Bay is connected as documented in the Technician's Handbook and that trunks and other facilities on the SX-200 ICP (if replacing) are reallocated to the 3300 MXe as required.
Note: SX-200 Bays are supported in North America only and use the same loss plan as 3300 ICP devices.
To program an SX-200 Bay:
License
and Option Selection form
Ensure that enough analog line licenses are programmed for the bay
in the License
and Option Selection form. Each line circuit in the bay, whether ONS
or OPS, requires a single analog line license. Calculate the number
of analog line licenses per bay as follows: 12 for each ONS/ONS CLASS
line card and six for each OPS line card.
Controller Module
Configuration form
Program a Dual FIM and/or Quad CIM as required to connect the Bay(s)
to the 3300 ICP. Up to seven bays can be connected to the 3300 MXe using
any combination of FIM or CIM connections.
Note:When programming a Dual FIM for use by a 200 bay the other FIM port cannot be used for anything other than another 200 bay.
Analog Services Units form
Click Change and enter
a value in the range 2 to 16 in the Unit field. The value is for identification
only and is used to differentiate between units when there are more than
one installed.
Select "SX-200 Bay" from the Programmed Type field.
Card
Assignment form.
Select the appropriate card types.
Each SX-200 Bay holds up to 8 Peripheral Interface cards, which provide
up to 96 ONS, OPS, or DNI ports.
Analog
Sets form
Program the ONS/OPS circuits.
Note: ONS/OPS circuits in SX-200 Bays use Circuit Descriptor Number 16 for their high and low flash timer value. See ONS/OPS Circuit Descriptors for the required descriptor settings. Descriptor 16 is only used for the flash timers and is not actually assigned to the Bay circuits. For other parameters, the circuits use whatever is in the descriptor they are assigned.
Single
Line DNI Sets, Multiline
DNI Sets and DNI
Consoles forms
Program sets and SC1000 consoles as required.